Techspray G3 Flux Remover 1631-16S, Aerosol, 16 oz

Techspray G3 Flux Remover 1631-16S, Aerosol, 16 oz

TS 1631-16S

Regular price $32.30

Only 999988 items in stock!

Techspray's G3 flux removers (defluxers) remove flux residues and other contaminants left by manufacture, rework, or repair of printed circuit boards. Residues from higher, lead-free temperatures are more baked on and harder to clean. G3®, Ecoline™ and Precision-V™ flux removers have been proven very effective at removing fluxes baked on at lead-free temperatures. Micro-components and fine pitch leads are delicate and easily damaged, so brushing and scrubbing should be avoided if possible. Both G3, Ecoline and Precision-V have a powerful spray and strong solvent that blasts off residues and cleans areas under components that a brush cannot touch. The power of G3, but specifically formulated to avoid and clean white residues caused by no­clean fluxes.

Features & Benefits

  • Powerful cleaner
  • Non-flammable
  • Non-ozone depleting
  • Safe on electronics
  • Rapid evaporation
  • Zero residue
  • Safe on most plastics
  • EPA SNAP approved
  • Proven effective for lead-free processes

Applications

  • Electronic Assembly
  • Electronic Repair
  • Soldering / Desoldering

Instructions
Make sure opening of sprayhead is pointing toward surface to be cleaned. Hold can 15-20 cm away. Direct spray to saturate soiled surface. A TechBrush® (2000 Series) may be utilized to help in the removal of heavy soils. When used as a general cleaner, start at top of area to be cleaned using a sweeping motion, and spray the area slowly, working towards the bottom. To clean in hard to reach areas, insert extension tube in sprayhead to direct spray. Allow components to dry completely before applying current. For flat surface cleaning, saturate a lint-free TechClean® Twillwipe (2357) or Purwipe (2355) and wipe surface with cloth. Rotate the cleaning side of the wipe periodically and re-saturate.

PDFTechnical Data Sheet
MSDS

You may also like


Recently viewed